Contrex M-Traverse Uživatelský manuál stáhnout pdf (Strana 169)

5 - 22

CP-31 HOME OFFSET

The Home Offset (CP-31) parameter allows you to offset the “Home” position and relocate it

somewhere other than the sensor.

If CP-24 is set at “1” (edge based), measure the distance from the sensor to the desired position

of “Home”. Enter that E.U. amount in CP-31.

Sensor

DIRECTION

OF WIND

Home

Edge Based

Home Offset

(CP-31)

FOLLOWER

LEAD

If CP-24 is set at “2” (center based), measure the distance from the sensor to the center. Enter

that E.U. amount in CP-31. The M-Traverse will make a transparent, internal calculation and

position “Home” at a distance that is CP-31 minus 1/2 of the traverse length. The position of

“Home” will change to correspond with any changes in the traverse length.

Sensor

LINE FLOW

FOLLOWER

LEAD

Home

Center Based

Home Offset

(CP-31)

NOTE: Since the “Home” position calculations are dependent on the Traverse Length param-

eter (CP-02, CP-14, CP-06, CP-08) and the Engineering Units parameter (CP-15),

those values must have already been entered prior to entering a value in CP-31).

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 201 202

Žádné komentáře

Contrex M-Traverse Uživatelský manuál Strana 169