Contrex M-Traverse Uživatelský manuál stáhnout pdf (Strana 65)

3 - 18

Dwell (CP-10)

The Dwell (CP-10) parameter allows the Follower mechanism to pause

at the end of the Follower profile before ramping back in the opposite

direction. In level wind applications, this parameter is a portion of the

encoder lines in one rotation of the reel (Lead). In web scanning

applications, this parameter is a portion of the encoder lines in one

traverse length. The Dwell parameter does not need to be an exact

number, the system will perform adequately with a close estimate .

The factory default for the Dwell Control Parameter is found in Table 3-12. To modify

the default parameter refer to Table 3-13. If you are uncertain how to enter a Control

Parameter, review the

Operations: Keypad

section.

Table 3-12 Default Dwell Control Parameter

CP Parameter Name Parameter Value

CP-10 Dwell 0

Table 3-13 Entering Dwell Control Parameter

CP Parameter Name Parameter Value

CP-10 Dwell In a level wind applications, enter a portion of the

encoder lines in one rotation of the reel

In a web scanning applications, enter a portion of the

encoder lines in one traverse length.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 201 202

Žádné komentáře

Contrex M-Traverse Uživatelský manuál Strana 65